#358: Drill Bolt™ Brick Veneer Shear Anchoring System |
| |
Drill Bolts™ are 1/2” thick (12.7mm) in diameter and 6.25" in length.
U-Clip is 14 gage.
Drill Bolt™ and U-Clip™ are Hotdip Galvanized after fabrication in compliance with ASTM A153 requirement of 1.5 oz/ft2/side (CSA CAN-A370-04 requirement of 460g/m2/side) of zinc coating. Product Submittal Sheet PDF |
PRODUCT FEATURES:
|
|
|
|
| |
Expert's Choice for the
Most Innovative Product Award at the 2009 World of Concrete Exhibition! |
|
|
|
|
|
| Complies fully with the Canadian and the US building codes |
|
|
-
Drill Bolt™ is attached to the stud side; the connecting screws are stressed shear.
-
Load resistance exceeds the requirements of CSA A370 and ACI 530
.
-
The total mechanical free play in the system does not exceed 1.2 mm, as required by CSA A-370.
-
The total sum of displacement under a load of 0.45 KN and mechanical free play in the system does not exceed 2.0 mm, as required by CSA A-370.
-
All parts are hot dip galvanized after fabrication per ASTM A-153, to comply with level 2 corrosion protection requirements as defined in CSA A-370.
|
|
|
|
 |
|
|
|
|
|
|
|
Rigid insulation integrity remains uninterrupted |
-
The Drill Bolt™ creates a very tight penetration without disturbing adjacent sheeting and insulation.
-
U-Clip™ adjusts rotationally from outside to seal the penetration and positively retain the insulation in place.
-
U-Clip™ slot can be installed up or down to allow total vertical adjustment of 2 ¾” (70 mm).
|
|
|
|
|
| Quick & easy installation |
- The Drill Bolt™ installs with a power drill; the cutting point will penetrate through the sheeting and insulation from inside.
- The Drill Bolt™ is equipped with a hex head matching the screw hex head so that only one tool is used.
- The Drill Bolt™ is notched to indicate the depth of insertion required.
|
| |
|
|
|
Application Profile View |
|
|
|
|
|
|
|
|
